Prodigy Autocode El manual del propietario descargar pdf (Pagina 10)

Diagnostic Devices, Inc. www.prodigymeter.com

Prodigy Talking Meter Owner’s Manual

Diagnostic Devices, Inc. 1.800.243.2636

Prodigy Talking Meter Owner’s Manual

About Prodigy

Control Solution

Prodigy

ControlSolutionisaredliquidthatcontainsglucose

that will react with test strips and produce a test result.

Prodigy

systems use a high or low control solution.

vFirst, check your contents to see if you have a high

or low control solution in your meter kit.



vThen, after completing a control solution test, compare

  resultswiththecorrectrange(highorlow)located 

on the back of the test strip vial.

Why perform a control solution test?

•Toensurethatyourmeterandteststripsareworking 

properly together.

•Topracticetestingwithoutusingyourownblood.

It is recommended to do a control solution test:

•Onceaweek(tomakesurethatyoucontinuetoget

 accurateresults).

•Whenyoubeginusinganewvialofteststrips.

•Whenteststripsareexposedtoextremeenvironmental

conditions.

•Ifyoudropthemeter.

•Ifyouchangethebatteries.

Control Solution Testing

STEP 9: Select Unit of Measure

Press and release the “M” button until

the unit of measurement you are choosing

appears on the display. Press the “SET”

button and the memory segment will start

ﬂashing. See Figures 14 and 15.

Yourmetercandisplaytestresultsin

milligramsperdeciliter(mg/dL)or

millimolesperliter(mmoL/L.)

•Themg/dLunitisstandardinthe

 UnitedStates.

•Themmol/LunitisstandardinCanada.

STEP 10: Delete Memory

When the “dEL” symbol and the ﬂashing

“M” symbol appear on the display, you can

choose to clear the memory. If you do not

want to clear the memory, press the “SET”

button again to skip this step. If you want

to clear ALL memory, press the “M”

buttonfor(4)foursecondsandboth“dEL”

and “M” will ﬂash. Press the “M” button

again to delete ALL memory. The “- - -” will

appear to indicate all memory has been

deleted. See Figure 16.

Set-upisnowcompleted.Pressthe“SET”

button to turn off the meter. “OFF” is

displayed before shut down. See Figure 17.

Figure 16

Figure 17

Figure 14

Figure 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comentarios a estos manuales

Sin comentarios

Prodigy Autocode El manual del propietario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Prodigy Autocode